Power Source Option #1: USB Cable
Wall adapter not included

  1. Connect USB cable into any compatible power source (wall adapter or USB power supply).
  2. Place four fingers into the Glow Mini Light.
  3. Lamp will turn on with motion-activated 60 second timer.
  4. Place thumb only into the Glow Mini Light.
  5. Lamp will turn on with motion-activated 60 second timer.

Power Source Option #2: Battery
4 x AAA batteries not included

  1. Insert 4 x AAA batteries (for best results, use brand new and high-quality batteries).
  2. Close and hold the battery cover. Push small latch up to lock into place. 
  3. Place four fingers into the Glow Mini Light.
  4. Lamp will turn on with motion-activated 60 second timer.
  5. Place thumb only into the Glow Mini Light.
  6. Lamp will turn on with motion-activated 60 second timer.

Pro Tip: To ensure full cure on nail side walls, turn fingers side to side as you cure.

Important Notes! Read Before Use: 
 
A. Only choose one of the two power source option.
Do not use both the USB cable and batteries simultaneously, this may cause an over surge of power.  
 
B. If the Glow Mini Light flashes three times consecutively, this is an indication that the power source is not strong enough. Try a different power source (wall adapter, USB power supply or batteries) and/or power outlet.  

C. Handle the USB port with gentle care. Do not force the USB cable into the port as this will cause physical damage not protected under warranty. Ensure the USB port is properly aligned prior to inserting. 

D. Remove from power source after each use. Failure to do so will result in power over-consumption and may cause the Glow Mini Light to reach end-life prematurely.